联系我们
服务热线
0755-88299956
电话：0755-88299956
传真：0755-88299954
信息咨询：info@topquality.cn
购买仪器：sales@topquality.cn
技术：support@topquality.cn
应骋：master@topquality.cn
VDS 200Q Series
主要特点：
Voltage up to 60 V, 2 ranges
80 V Extended Option
Current up to 200 A (600 A peak)
Four quadrant, bipolar amplifier
Fast step response time
Very Low Ri: <10 mOhm (Programmable 10 - 200 mOhm)
High Bandwidth up to 250 kHz
Temperature-controlled air
VDS 200R Series
主要特点：
Voltage up to 60 V
Current up to 100 A (200 A peak)
Two quadrant
Fast rise time
Very Low Ri, <10 mOhm
High Bandwidth up to 150 kHz
Temperature-controlled air cooling
Pre-programmed test routines to simulate various supply waveforms
RDS 200N1
主要特点：
16V/10A DC voltage source
DC - 50 kHz bandwidth
Sine ripple capability of 8Vp-p
Built-in current sink
0 - 10VDC analog input for control by AutoWave (or any other signal generator) or PFS 200N
LCD Display for voltage and current
Over voltage/over cu
AutoWave
主要特点：
Dual-Processor-Technology, 500kS/s sample rate
Up to 4-channel arbitrary generator
Optional 2-channel recorder
Simultaneous recording/generation
Library of standard test routines
Pseudo-random function
60GB built-in hard disk
Multiple interfaces
PFS 200N Series
主要特点：
Standalone test generator for voltage dips and interruptions
Rise/fall time <1us
Electronic short-circuit protection
Rated voltage 80V DC
Front panel operation
Standard Test routines
USB and GPIB interfaces
PFM 200N Series
主要特点：
Switch for Power supply (100 A / 200 A) and signal/data lines (2 A)
Pulses E10 and E13 of the LV 124/LV 148 standard
Bidirectional current direction
Separate switch in the ground line
Rise/fall time less than 200ns
Built in short-circuit switch <
CN 200Nxxx Family
主要特点：
Frequency response 10 Hz to 500 kHz
Secondary saturation up to 300 A
Audio power 200 W per transformer
Turns ratio 2:1 step down
CN 200N1
主要特点：
Frequency response 10 Hz to 250 kHz
Secondary saturation up to 50 A
Audio power 2 x 200 W
Turns ratio 2:1 step down
Freely configurable on primary/secondary; serial, parallel, single
Built-in non-inductive load resistor 0.5 ohm, 250 W
AMP 200N
主要特点：
Automatic Closed Loop test procedures
Built-in DDS sinus signal generator up to 500 kHz
Output voltage max. 160 V p-p, 50 V rms
Output current max. 18 A rms
Designed for EV's and much more
Supports magnetic field tests up to 1100 A/m
Short-circuit p
Transient Emission Set
主要特点：
BS 200N100.1 - Electronic switch, 60V DC/100A:
- Volt.Drop <1.2V@100A, <0.2V@25A
- Peak voltage max. 1,300V
- Reverse-polarity/short-circuit protected
BSM 200N40 - Mechanical switch, 12/24V DC/40A
AN 200N100 - ISO 7637-2, CISPR 25, CISPR 16-1-
RCB 200N1
主要特点：
Approved by Ford acc. to FMC 1278 and EMC-CS-2009.1 requirements
Pulses CI 220: A1, A2-1, A2-2, C-1 and C-2
Pulse CI 260: F
Pulses RI 130: A2-1, A2-2 using a coupling test fixture
Fixed repetition times and pseudo-random timing
Automatic control of
LD 200N series
主要特点：
Load Dump generator according to ISO 7637, ISO 16750-2, SAE J1113, SAE J1455, JASO, Nissan and most car manufacturer requirements
Generates Clipped Load Dump pulses
Built-in 0.5 - 38 Ohm source impedance, selectable in 0.1 Ohm steps
Pulse duration u
客服1
客服7